RANGE OF PERFORMANCE |
Flow rate up to 42 gpm
Head up to 190 ft |
LIMITS OF USE |
Manometric suction lift up to 23 ft
Liquid temperature up to + 194°F
Liquid temperature up to + 104°F in the CPX version (with technopolymer impeller)
Environment temperature up to + 104°F |
INSTALLATION AND USE |
They are recommended for pumping clean water and liquids that are chemically non aggressive to the materials from which the pump is made.
RELIABLE AND MAINTENANCE FREE THEY ARE WIDELY USED IN THE DOMESTIC AND CIVIL SECTOR, IN PARTICULAR FOR WATER
DISTRIBUTION IN COMBINATION WITH SMALL OR MEDIUM PRESSURE SETS, FOR TRANSFER IN GENERAL, FOR IRRIGATING GARDENS.
The pumps must be installed in enclosed places, or at least protected against inclement weather. |
|
|
CONSTRUCTION CHARACTERISTICS |
• PUMP BODY: cast iron, with threaded ports.
• BODY BACK-PLATE: stainless steel AISI 304 or cast iron on higher powered models.
• BRASS IMPELLER
• MOTOR SHAFT: stainless steel EN 10088-3 - 1.4104.
• MECHANICAL SEAL: ceramic - graphite - NBR.
• ELECTRIC MOTOR: the pumps are close-coupled to a carefully matched PEDROLLO electric motor, quiet running, totally enclosed
fan cooled (TEFC), suitable for continuous duty.
CP: single-phase 115 V or 230 V - 60 Hz with capacitor and thermal overload protector built into the winding.
CP: three-phase 230/460 V - 60 Hz.
• INSULATION: class F.
• PROTECTION: IP 44.
• REGISTERED MODEL nº 72753.
|
OPTIONS ON REQUEST |
• impeller in technopolymer (CP...X - CP...X)
• special mechanical seal
• other voltages or frequency 50 Hz |
|
![.](images/spacer.gif"){kind=spacer}
